
Surface LED baseboard, flat face
Surface-mount baseboard with a flat face. The LED channel sits at the floor line and lights down to the floor.
Ten aluminum baseboards with a hidden LED channel. The set covers surface, plaster-in and recessed (in-wall) mounting, with the light at the floor line, at the top and bottom, or in the shadow gap under the board edge.
Used at the wall-to-floor junction.
Each card shows the N&N code, a product or section image, the dimensions we have, where the LED sits and how the profile is mounted. If a dimension is not listed it is confirmed on the section drawing sent with your quote. Click any image to open it full size. Request a quote to prefill the code on the quote form.

Surface-mount baseboard with a flat face. The LED channel sits at the floor line and lights down to the floor.

Surface-mount baseboard with an oval lower lip. The LED is hidden in the lip and lights down to the floor.

Plaster-in baseboard set flush with the wall finish. The light line sits at the floor.

Plaster-in baseboard with an 80 mm flange, finished flush with the wall. The light line sits at the floor.

Baseboard with separate top and bottom LED channels (up and down light), a clip-on face and diffusers.

Baseboard with top and bottom LED channels, a molded clip-on face and diffuser.

Surface-mount baseboard, 90 mm high, with LED channels at the top and at mid-front, each fitted with a cover. Section drawing on the product image.

Plaster-in baseboard with the LED channel at the back / middle of the section, lighting down to the floor. Source dimensions are 16 x 45.8 mm; orientation is confirmed on the section drawing sent with your quote.

Surface-mount baseboard, 90 mm high, with an oval lip that hides the LED strip and lights toward the floor.

In-wall baseboard set into a drywall rebate. The LED sits in the shadow gap under the board edge.
If the section you need is not in the two families above, a new aluminum extrusion die can be cut to your drawing. Send a sketch, a photo of the detail or a CAD section with the key dimensions. A dimensioned section is sent back for approval before any die is made. Die cost, sample timing, lead time and minimum run are quoted per project.